busybee Food

Base recipe for 1 liter of root beer: half a tablespoon of root beer extract (I use Zatarain’s) and half a cup of sugar (raw/turbinado sugar is especially nice).

For typical root beer, make half a cup of simple syrup by combining the sugar with half a cup of water and heating until the sugar is dissolved, then add it and the extract to 750mL of sparkling water.

However, for home-brewed root beer, which has a more complex flavor (and a slight amount of alcohol), combine the sugar, extract, 1 liter of water, and 1 teaspoon of yeast (baker’s yeast is fine, champagne yeast is better) into a clean 1-liter plastic bottle. Squeeze the air out and cap, and allow to sit at room temperature until the bottle has expanded and become firm to the touch, and then move it into your refrigerator to chill. This process depends on the temperature, and can be sped up or better controlled using a sous vide circulator set to around 90°F which should make the fermentation take only a few hours.

NOTE: Be absolutely careful not to let this stay out past the time it has gotten firm, or else you run the risk of the bottle exploding and making a mess! And, for that matter, only use a flexible plastic bottle (I use leftover seltzer bottles) and not a firm bottle like a SodaStream or, worse yet, a glass bottle, as those will be very difficult to use safely and are very likely to explode on you.

Anyway, the nice thing about brewed rootbeer is that the flavor will continue to develop over time in the refrigerator, and it won’t easily go flat, as the yeast will continue to ferment and carbonate it even while cold. (This will also increase the alcohol content over time.)

I highly recommend storing the bottle upright, if possible, as the yeast will form a sediment on the bottom of the bottle and this doesn’t have a very good taste or texture. Keeping it upright makes it easier to pour off the root beer without ending up with the yeast slurry.

• 20mL agave nectar
• 20mL of lemon or lime juice (or a combination of them, totaling 20mL)

Combine the above, and then add to 1 liter of sparkling water.

For an extra kick, add some powdered ginger, or replace some (or all) of the agave nectar with ginger syrup. And maybe a pinch or three of cayenne pepper.

I just made some ginger ale syrup for making home-made ginger ale. It’s pretty easy! Just peel some ginger (use a spoon to remove the skin so you don’t waste the tasty flesh) and chop it up into thin-ish chunks, and put it into a saucepan with some water, some sugar, and other flavorings as you see fit (I used some pomegranate molasses, some coriander seed, and the peel and juice of a lemon). Then heat the water up and let the ginger steep for a while, then slowly bring it to a low boil.

Occasionally test the flavor, both to adjust the sugar level and to know when it’s gingery enough (don’t worry about extracting EVERY LAST BIT of ginger flavor, as that’s impossible and the point is to make something that tastes good, right?), and when it has a good flavor, use a wire strainer or the like to fish out as much solid stuff as you can. Then raise it to a moderate boil, and let it boil down until it’s 225-230F (don’t let it go any higher than that though, since at that point it starts to turn into candy).

Let it cool, and while it’s still warm and runny, strain it through a mesh strainer into a storage bottle of some sort.

To make the ginger ale, just mix some of the syrup with some soda water.

For bonus points, the chunks of ginger can be rolled in sugar and then put into an oven at 250F or so to dry them out a bit. And this is how you make candied ginger.