What time is it? Unstructured rambling time! fluffy rambles
Just the current haps, yo.
Studio reorg, day 1 fluffy rambles
The air was clear enough™ today (AQI in the upper 80s, which is still no fun for me to be outside but that’s good enough for being in the basement) and I got goaded along by some folks on the Song Fight! discord to “just do it,” so I decided to start the process of reorganizing stuff.
Resin printing adventure fluffy rambles
So far I haven’t gotten a fully-successful resin print, but I’m inching closer and closer.
The current issue I keep running into is that it’s very difficult to separate a print from the bed, and I think I need to give up on having a good clean bed-adhered surface. It’s better to give all prints lift and support, probably, even if that means having more tiny surface defects on the side facing the build plate (which is better than having an entire shattered print when I inevitably resort to a hammer to separate it).
I also ran into a problem where somehow a bit of resin got underneath my FEP film (hopefully due to my own carelessness and not due to a leak I haven’t found on my vat!) and some resin got caked to the LCD. Fortunately, Phrozen’s suggestion of soaking it in 91% IPA and then using the plastic scraper to get it off worked just fine.
Anyway. For now I’m still stuck trying to sun-cure my prints, but hopefully I can figure out a decent cheap curing station setup. I’m thinking of building a curing box using UV LED strips but it’s so hard to find reliable parts for that sort of thing. I also ordered a cheap curing station off Amazon but I’m not expecting great results from it.
In the meantime, my FDM printer is working again, and now that I have a decent supply of isopropyl alcohol I can actually get prints to stick to the build plate!